Note:
The difference between the "deluxe series" and the "standard series" of our Radar Mounts is the
Radome
mounting plate material.
The "standard series" uses an extremely sturdy Polymer Radome mounting plate.
The "deluxe series" uses a more expensive Aluminum plate.
All other parts are identical.
Our Radar Mount is modular in design
and allows configuration to your
exact requirements, eliminating
the need for expensive custom design and fabrication.
The Mount is available
in heights of 4, 8, 16 and 24 inches.
Note: Heights are approximate and depend on optional hardware mounted.
In its basic configuration the Mount includes everything needed to mount
the Radar Radome.
With optional antenna/light arms and light brackets (see parts/price list), our mounts allow mounting
a variety of
lights and antennas such as
GPS, VHF, FM and TV etc.(in addition to the Radome)
Up to 2 antenna/light arms can be mounted.
Antenna/light arms will work with Radomes up to 20 inches in diameter.
Provisions
are made to route all cables through the tube of the Mount and then
either straight down or
out of any side of the base.
The Radar Mount consists of a stainless
steel assembly, with a 7 inch square bottom flange, the tube,
and a top flange onto which
the Radome mounting plate of your
choice and the optional antenna/light
arms
and light brackets are mounted.
A plastic base-spacer that can be modified by the installer to match the curvature
and angle of the
mounting surface on your boat
is included.
A wedge shaped (4deg) base-spacer is available if needed.
-
The quality of workmanship and material is without compromise.
-
No powder
coated castings are used.
The Radar Mount base, tube and top flange are made of type 316L stainless steel.
The Radome
mounting plates and antenna/light arms are machined from
marine grade aluminum alloy.
We do not believe that powder-coating is suitable for a marine environment.
All aluminum parts are anodized, primed with
epoxy primer and finally coated with a highly UV
resistant
Polyurethane (white).
All metal finishing is done to military specifications.
For aesthetic
reasons, we do not make universal Radome mounting plates
with unsightly slots and unused holes.
The Radome mounting
plate is machined to fit your brand of Radar antenna.
